Skip to content

VAT and MTD

VAT on labour and new builds: which rate applies?

Trade Tax Specialists Editorial Team6 min read

Labour on an existing building is normally 20%. Building a new home is zero-rated, and qualifying conversions and renovations of homes empty for 2 years are 5%. The rate follows the building and covers the materials you fit. The reverse charge never changes it.

Figures checked against primary sources (HMRC, legislation.gov.uk, HMRC CIS guidance) in 4 November 2026.

Key takeaways

  • There's no separate VAT rate for labour. Your work and the building materials you fit share one rate: 20% on an existing building unless an exception applies.
  • New-build homes are zero-rated, not exempt: you charge 0% and still reclaim the VAT on what you buy for the job.
  • Conversions into homes and renovations of homes empty for 2 years are 5%. Subcontractors normally follow the building's rate, except on certificated buildings, where they charge 20%.
  • The domestic reverse charge applies to 20% and 5% work only. It changes who pays the VAT to HMRC, never the rate.

VAT on labour is 20% on normal building work: repairs, refits, extensions and decorating on a building that's already standing. Build a new house and the same labour is 0%. Convert a barn or an office into homes, or renovate a house nobody's lived in for 2 years, and it's 5%.

So your trade doesn't set the rate, and nor does being labour-only or supply-and-fit. The building and the job set it, and the building materials you supply and fit go on at the same rate as your work. HMRC's rules are in VAT Notice 708, last updated on 26 August 2026. The domestic reverse charge is a separate step on top: it changes who pays the VAT, not the rate.

Calculator

CIS VAT Domestic Reverse Charge Checker

The VAT domestic reverse charge (DRC) applies to most CIS construction services between VAT-registered businesses. Getting it wrong means either charging VAT you should not (forcing your customer to claim it back) or not charging VAT you should, risking HMRC penalties. This checker runs HMRC's reverse charge conditions for building and construction services and gives you the exact wording for your invoice.

£

Used only to generate the invoice wording example and show the CIS deduction on the labour amount. VAT and CIS are calculated on this figure, independent of each other.

Your result

Your answer's ready. Press below to see it.

Do you charge VAT on labour at all?

Only if you're VAT-registered. You have to register once your taxable turnover goes over £90,000 in any rolling 12 months, or you expect it to in the next 30 days alone (the threshold since 1 April 2024). Below that, you can register voluntarily, and if you don't, there's no VAT on your invoices.

Once you're registered, 20% is where you start. In Notice 708's words: "The construction of a new building and work to an existing building is normally standard-rated."

The three rates side by side

The jobRateWhat has to be trueNotice 708
Repairs, maintenance, refits, extensions and decorating on an existing building20%Nothing. It's the defaultParagraph 2.1
Building a new house or flats0%Built from scratch, designed as homes that can be used and sold separately, with planning consent, and your work's done before completionSection 3
Turning a non-residential building into homes, or changing the number of homes in a building5%A qualifying conversion, with planning consent or building control where the work needs themSection 7
Renovating or altering a home5%Nobody's lived in it during the 2 years immediately before your work startsSection 8

What counts as a new build, and what doesn't get the 0%

On a new home, zero-rating covers your work "in the course of the construction" of the building, from groundworks to decorating, and the building materials you fit while you're at it. That includes things a builder would normally fit in a house, like fitted kitchen units, boilers and floor tiles (section 13).

It's zero-rated, not exempt, and the difference is money. A zero-rated supply is still a taxable one, so you reclaim the VAT on your materials and other job costs as normal (paragraph 2.3.1). If the work were exempt, you couldn't.

That's why there's no such thing as a new build VAT exemption list. What there is, though, is a list of things that stay at 20% even on a zero-rated site:

  • architects, surveyors, consultants and supervisors (paragraph 3.4.1)
  • hire of plant without an operator, scaffolding, security fencing or mobile offices, though putting up and taking down the scaffolding can still be 0% (paragraph 3.4.2)
  • carpets and underlay, and fitted furniture other than kitchen units, with a narrow exception for basic built-in wardrobes (paragraphs 13.5 and 13.7)
  • plug-in appliances, and hobs and ovens (paragraphs 13.3 and 13.6)
  • work after the building's complete, including fixing someone else's snags (paragraphs 3.3.2 and 3.3.3)

Watch mixed buildings. Build a shop with a flat above and only the flat's zero-rated, so your price gets split fairly (paragraph 3.5.1).

Want this checked against your specific situation?

Leave your details and a one-line summary, and we'll look at your position. No obligation.

Step 1 of 2, about you

Step 1 of 2, about you

When is building work 5%?

You've got two routes. The first is a conversion: turning an office block or a barn into a house or flats, or changing how many homes a building holds, like splitting a house into flats (section 7).

The second is a home that's stood empty. If nobody's lived in it during the 2 years immediately before your work starts, your repairs, redecoration, double glazing and even an extension done as part of the renovation are 5% (section 8). Squatters, property guardians and storage use don't count as living there, but a second home used now and then does. A letter from the council's Empty Property Officer is enough proof on its own (paragraph 8.3.2).

Inside a 5% job, some things still go on at 20%: carpets, fitted bedroom furniture, scaffolding, hired kit, landscaping and professional fees (paragraphs 7.6 and 8.4). If you don't split the bill, none of it gets the 5%.

Does a subcontractor charge the same rate as the main contractor?

Normally, yes. Notice 708 says subcontractors can zero-rate or reduce-rate "according to the building being constructed or worked on" (paragraph 2.1.3). So a labour-only bricklayer on a new house charges 0%, and a plasterer on a barn conversion charges 5%, the same as the builder above them. There are three exceptions you can't follow the main contractor on:

  • Certificated buildings. A care home, student halls or a charity's village hall gets its relief through a certificate the customer gives the main contractor. As a subcontractor you can't use it, so you always charge 20% (paragraph 17.4).
  • Housing association conversions. The main contractor can zero-rate, but your work isn't made to the housing association, so you don't get the 0% (paragraph 6.2.3).
  • A long-empty home the new owner's already living in. The builder working for the owner direct can charge 5%; a subcontractor charges 20% (paragraph 8.3.4). If the house is still empty when the work starts, you follow the builder's 5%.

Whatever the rate, the reverse charge is a separate question, and the reverse charge checker answers it for a single job.

Four worked invoices

Example figures, and every job assumes you're VAT-registered.

The jobRateLabourMaterialsNetVATInvoice total
A. Kitchen refit in a lived-in house, for the homeowner20%£2,400£1,600£4,000£800£4,800
B. Supply-and-fit brickwork on a new house, for the housebuilder0%£6,000£2,000£8,000£0£8,000
C. Plastering a house empty for 3 years, for the owner5%£3,000£500£3,500£175£3,675
D. Rewiring a lived-in house, as subcontractor to a builder20%, reverse charge£2,000£1,000£3,000£600, paid over by the builder£3,000

Job A. The 20% goes on the whole £4,000, not just the labour: £480 on the labour and £320 on the materials. You paid £320 VAT on those materials at the merchant and reclaim it, so the materials VAT washes through and the £480 on your labour is what's left.

Job B. Nothing goes on the invoice, but you still reclaim the £400 VAT you paid on £2,000 of bricks and blocks. Job C is 5% of £3,500, so £175. Carpet laid on the same job would be 20%, as it isn't a building material.

Job D is where the reverse charge bites. All five conditions are met: rewiring's a CIS service, you're both VAT-registered, the builder reports the payment under CIS, the builder isn't the end user because it's selling the work on, and the work's at 20%. So you don't charge the £600. Your invoice shows £3,000 with a reverse charge note, and the builder pays the £600 over on its own return. The rate hasn't changed. How to invoice under the reverse charge has the exact wording and what changes on your return.

The builder's also your contractor under CIS, so if you're registered it'll deduct 20% from the labour only, never the materials. That's £400 on job D (you're paid £2,600) and £1,200 on job B (you're paid £6,800).

The reverse charge works the same way at 5%: do job C as a subcontractor to a registered builder and you'd show the £175 for the builder to pay over. It never touches 0% work, so job B stays an ordinary zero-rated invoice. And if the reverse charge part of a supply is 5% or less of the contract's value, and you and the builder agree that at the start, you ignore it and use normal VAT rules for the lot. It's judged on the contract values, not invoice by invoice. If you're the builder receiving these invoices, the contractor's side of the reverse charge covers end-user notices.

Getting the rate right before the invoice goes out

Three questions settle it, and they're easier to answer when you price the job than after the invoice has gone. Is the building new, being converted, or empty for 2 years? Has the customer given a certificate? And who are you working for: the owner, a builder, or a developer selling the homes on? We'll go through them with you and tell you the rate, whether the reverse charge applies and how it lands on your VAT return. Here's what we do on VAT and the reverse charge. We reply within 24 hours.

Want your VAT and MTD setup checked?

The domestic reverse charge and Making Tax Digital change how construction invoices and records have to work. We'll check your invoicing, your records and your software against what HMRC requires.

Optional: a bit more detail (helps us prepare)

We'll only use your details to respond to your enquiry. We don't pass them to any other firm. See our Privacy Policy.

We'll be in touch. Your details are stored securely.

Frequently asked questions

Is a granny annexe on a new build zero-rated?
Usually not. Zero-rating needs a building designed as a dwelling, which means it can be used and sold on its own. If planning consent ties the annexe to the main house, your work on it is 20% (VAT Notice 708, paragraphs 3.2.2 and 14.2).
Does knocking down a house and rebuilding it count as a new build for VAT?
Only if the old house comes down to ground level first. You can keep cellars, basements, the ground-floor slab and party walls shared with the neighbours, but if you keep part of the old house and build round it, that's work to an existing building at 20%. A retained facade only counts where the planning consent requires it (Notice 708, paragraphs 3.2.1 to 3.2.4).
Does zero-rated work count towards the £90,000 VAT threshold?
Yes. Taxable turnover is everything you supply that isn't exempt, and zero-rated work is taxable. So a bricklayer working only on new houses can still have to register. With only zero-rated work, you'll be reclaiming VAT on materials while charging none, so HMRC pays you.
I'm building my own house. Will the trades charge me VAT?
Not on the building work, if the house qualifies as a new dwelling: their work and the building materials they fit are zero-rated. Materials you buy yourself carry 20%, and gov.uk's DIY housebuilders scheme (Reclaim VAT on a self build home) lets you claim VAT back on building materials and services in one claim, made within 6 months of finishing. It only refunds VAT that was correctly charged, so check the invoices first.